How to create a 3D jewellery set

What you require:

Findings – These can be various dependent on particular choices:

Tools:               

Guidelines:

1. First you will require to observed/file the sprue off the parts
2. You can pre buff/ pre polish the star pieces which helps make cleaning easier right after soldering
3. Using buff sticks to buff back the solid complete heading from coarse to high-quality
4. As soon as you have acquired to great buff paper you can start off to polish using luxi compound –blue for to start with phase with the calico mop
5. There are information marks on the point of the star pendant and earrings you want to solder jump rings to
6. You can file jump rings with triangular file to give them an angle at the ends so they sit flat from the stage of the star
7. Apply solder paste where by the guidebook marks are on the stars
8. On the soldering block, drive the bounce ring against the stars information marks and use tweezers to maintain the soar ring in area
9. Using the hand torch, heat up the reliable star and when it is starting up to change color little by little go alongside to the leap ring so it gets to tempreture at exact same time until eventually the solder melts and joins the items jointly
10. Quench and put it in pickle, rinse just after pickling to clean off acids.
11. If you did not buff and pre polish previously now you will want to buff back the forged end and if you will need to eliminate any added solder
12. Polish the piece applying luxi compound – blue for very first stage utilizing a calico mop
13. Then polish with White luxi compound and a fluffy mop
14. For your earrings you can open up up your ear wire and then near it back again with each other
15. For the star pendant necklace, dependent on the bail you choose you can both incorporate it specifically the the soar ring or if essential you could require to include another smaller bounce ring right before the bail.
16. Ultrasonic or clean off any residual polish and include a chain to the pendant.

Optional: you can either totally close your results by soldering them all through soldering step 9 or depart the results semi open up and just pushed alongside one another .

Help you save this for later